Skip to main content

Cool Glasses: Environmental Eyewear + Measurements

I began rethinking my eye-wear as I didn't really feel comfortable with the strength of my concept and decided it to tie in the concept with my research on the human perception of place and environmentalism.
From that I came to the idea of representing our melting polar ice caps as glasses as ice masses that protect the planet from the suns rays using the white colour of snow and ice to reflect the suns rays much like sunglasses.
I then imported images of Antarctica and Greenland with the pictureframe command and traced them with the control point curve
traced map of Antarctica 

traced map of Greenland 

Here are the final outline
I then extruded the curves to be implemented into the eyewear
I then replaced the lenses of the glasses with the two ice covered land masses





I then measured the smallest and largest widths of the nose bridge of my own glasses


then implemented the measurements into the rhino sketch
I then also translated the measurements from my glasses to the rhino design




Here are the rearranged positions of the ice masses to better conform to the glasses while sacrificing identifiability for funtionality.

here i measured the arms of my glasses at 6inches
hen made the correct length arms from lofted circles and an added sphere tip as to not stab oneself while still maintaining the icicle aesthetic.



I also extruded the lenses to be a half inch on the frame and a half inch relief for the land outlines



here is the rear and front view showing the rounded end pieces to keep the icicles from being too tight on the face. a problem I had with my paper prototype.

front view highlighting the arm corner design














Comments

Post a Comment

Popular posts from this blog

Deconstruction of a lighter: Progress

For my reverse engineered object I had first chosen a lighter though after realizing I could not take it apart without destroying it I chose to the "Bic" lighter, a commonplace lighter sold around the world.  (Flick my Bic? that just sounds wrong) (The Bic Dissembled) Oval shape for the lighter The Lighter  body curve extruded and caped overlapping and oval with and oval trim to the shape  of the  red plastic lighter gas button and metal flame housing Post triming Once curveextruded we have the two approximattive shapes I then created the  springs using the  "spiral command" and counting the spirals on each of the lighter springs./ extruded cylinder for the easy to model flint flint capped and shaded gas  nosel approxamitive  shape Spark wheel: a circle and 60 pointed star Curve extruded rigged parts and center cylinder caped spark wheel Everythin...
1 comment
Read more

"Cool" glasses paper + cardboard prototype

For my prototype I began in 2D sketching from my rhino file, though changing the arms i had originally planned by directly running them from the back of the round lenses in an effort to make the glasses look more designer"esque" and less goofy. I still currently want to pursue my concept of commenting on material culture and the ephemeral nature of apparel such as glasses. I then traced and layered cardboard to add thickness and create the form. I then glued the layers together with a glue stick. I then used the same process to create the nose bridge using only 2 cardboard layers. I rolled paper to create stretched cones to act as the arms of the glasses, also reminiscent of icicles. I then hot glued the arms to the frame  finished prototype I'm looking forward to feedback tomorrow and am looking at ideas of incorporating more references to ice and the cold into the design of the glasses.
Post a Comment
Read more